A three-pronged carpet care program will prolong the life of the carpet and enhance the image of your facility. Restorative cleaning is the process that renews visibly soiled and dingy carpet. It is typically performed once annually.

The extraction process remains the same regardless of which type of extractor you use. Your Maintex representative can help you select the correct model for your needs.

Detail vacuuming the entire area will removes the surface dust and grit. Remember to inspect the area for heavily trafficked wear conditions and spots.

After placing wet floor signs and putting on PPE, dilute First Step pre-spray into a large pump sprayer and apply to soiled areas. Agitate the surface with a carpet brush or rake.

Treat any visible spots and stains by spraying carpet spotter directly onto the stain. Let the product dwell for at least 5 minutes.

Use the extractor to thoroughly clean, rinse, and vacuum the carpet. When you are finished, use air movers to accelerate the drying process.

Add warm water to the carpet extractor’s solution tank, then add Last Step Carpet Rinse according to label directions.

Begin with one ounce of defoamer in the recovery tank. After a few passes, check for excess foam and add more defoamer if needed.

Always clean from the point farthest from the exit. You do not want to walk over damp carpet.

Operate the extractor by pulling it towards you. This way you avoid walking on wet carpet and the vacuum shoe can properly extract liquid and debris.